NO-COAT Structural Laminate Drywall Corner System

• NO-COAT® drywall corners have a built-in flexible hinge that can adjust to any angle. If a wall is far out of plumb, simply pinch the NO-COAT® drywall corner and adjust it accordingly. We also recommend applying an excess of All-Purpose joint compound to compensate for large gaps.

• Tape and coat drywall board seams and ceiling joints before applying NO-COAT® corners. This will create a smoother surface for corner trim application, and a straighter finished profile.

• When storing ULTRATRIM™ corners, lay boxes flat on the floor. Leaning boxes against a wall may eventually cause the corners to warp.

2. Using a 4” – 6” taping knife, apply All-Purpose joint compound to drywall slightly beyond where the edge of the corner will be. Place NO-COAT® corner trim on wall and press into position. NOTE: The joint tape side (with the NO-COAT® logo) of the corner goes against the drywall.

3. Embed corner trim using a NO-COAT® ULTRATOOL™ WIDE OUTSIDE 90 & BULLNOSE Roller or by running the knife over it with even pressure at a 45 degree angle.

5. Using a 6” – 8” finishing knife, skim over the corner once more with All-Purpose joint compound. Let dry. Sand and paint.

The NO-COAT®  Double Barrel Hopper
The NO-COAT®  Hopper accommodates all inside and outside drywall corner angles without time-consuming part changeovers and reconfigurations.

TIP: Before filling the NO-COAT® Double Barrel Hopper with All-Purpose joint compound, run a short piece of corner trim through the Hopper gates. This allows you to make the most accurate tolerance adjustment. To avoid run off, compound should have the same consistency as boxing mud.

ULTRATOOL™ WIDE OUTSIDE 90 & BULLNOSE Roller
Applying our corners is fast and easy. Simply place the ULTRATRIM™ Wide Outside 90 corner on the wall and use our roller to press it into position.